Plumbing & HVAC Services Pioneer OH

I wave install

After inspection of furnace I found the primary issue as to why the furnace is not working is because 2 of the 3 burners will not light, The draft fan motor is working but is very noisy, and the blower wheel desperately needs cleaned. I suggested to customer that we replace the burners and draft fan motor, also we need to clean the blower wheel

Furnace was sending an open pressure switch code, the draft fan motor was also making an awful noise. After inspecting unit I found that there was a bird stuck in the draft fan housing causing a restriction in the exhaust vent. Once I got the bird out the furnace ran just fine

Install new therostat

Whole house backing up drain clean after clearing drain recommend dig job and replacing pipe that goes under home too outside it is sagging and pooling water and recommended locating where tree roots are coming from too replace pipe customer does not want to do anything else besides clearing line and watched water flowing for 20 mins too make sure.

Performed ac tune-up. Verified proper operation. Replaced 16x25x1 filter. Replace dual capacitor in condenser.

PH2 Investments Upon arrival I found package unit #3 was not running. I found a communication error from the EMS board which was not calling for cool at the unit. I contacted EMS troubleshooting number and was able to have them correct error by logging into the store location. I verified all systems were operating properly before leaving. Payment was collected on site. Correct location is Family Dollar address 201 S State Street Pioneer, Ohio 43554. Office will correct invoice location during business hours. Work order # 136872 Closing # DE144907661344

There is a gate valve that the customer wanted us to change to a ball valve before the hose bib. We changed it out and tested for proper operation. No service fee since we were already here for a tuneup for ac

Worked on water heater installed new water heater that was sold tested for leaks. No leaks. System is running right now seen that there was no chimney liner. Will give customer a quote on a chimney liner that is needed. Estimate provide for chimney liner

Scoped and clean both supply and return ducts. Collected payment day of.

Old control gas valve would malfunction every so often, we changed it out and started it up. Control works as normal

Install dryer vent

Found no issues with furnace. Cleaned trap and verified proper operation. Issues were likely caused from wind. Need to schedule customers tune up

Installed humidifier and verified operation.

Ran new drain line to main and verified proper operation of sink.

Quoted customer for replacement of kitchen line.

Found air supply pipe to be broken off humidifier. Took pictures to see if we can order new front cover to properly reattach pipe. Also quoted 2 options for humidifier in case we can’t get cover.

For this job, I performed cleaning the blower on the furnace system. After I reconnected everything, I checked the operation of the furnace. Turning it off and on, I was able to have the furnace running normal. I did not find any other issues with the system Overall rating for the system is great.

Install whole house sediment filter.

Installed garage heater and ensured system was working properly.

Ran large machine through drain and cleared blockage. Did not have camera to confirm condition of pipe. Customer said they are okay for now and will give us a call if they would like us to return to run camera.

Found damper to be bypassed. Inspected unit and found burner rollout to be bad. Bypassed burner rollout to verify operation. Removed temporary bypass From rollout as it is a liability to run unit like that. Customer stated he will purchase his own rollout and install. Advised customer not to bypass rollout as it is a safety hazard.

instilling a LP generator.

When arriving at customers house, instead of installing two hose bib, the customer wanted me to change his front hose bib. After installing the hose bib, I checked for leaks and the operation to find it working great. I did not find any leaks. System working properly.

When arriving at the customers house, I pulled the Freon into the air conditioning, then to proceed to fix the kink on the 3/4 line. I use 3/4 and 3/8 coupling. After pulling down the vacuum, I release the charge and turn on the AC to make sure it is working. AC system cooling house down. Working great.