Plumbing & HVAC Services Edgerton OH

I performed a precision heat tune-up on the unit in Edgerton, OH. The system is in good working condition. The filter used is a Honeywell 16x25x4. No issues were found during the inspection, and the system is ready for the heating season.

Found bad blower motor in furnace. Office to order. Will install upon arrival.

Filter sold in office 8/1/2022, invoice was not previously sent. Invoice sent for customer records on 9/5/24.

Filter sold in office October 2022

Did a cleaned and tune and checked charge and only thing I seen that needed done was a new 40/5 cap

Performed precision tuneup on ac. Everything looked good except the capacitor was getting very low. Customer agreed to change it out before it became a problem

Found pressure switch from well was shorted out. I found the breaker was tripped. I replaced switch and reset breaker. I had to turn off main power in order to kill power and when I did I found the main 100 amp breaker was shorted out and found the bar was melted. Customer will need new sub panel. She accepted quote for replacement. Customer is without water and will need panel replacement asap.

Performed ac tune-up. Found unit low on r410a. Put in 12oz of r410a. Verified proper operation.

Performed ac tune-up on geo. Changed tstat due to malfunction. Verified proper operation of new tstat and ac. Showed customer inside of geo, customer wants price for I-wave.

Found unit low on r22 and condensate drain plugged

Ac unit was not running, I found that a fuse from the disconnect on the house by the meter was bad. When I changed it out the unit started up and ran as it should

When I got here the compressor wasn’t running but fan was. Customer stated their house was stuck by lightning. I checked capacitor and found it was bad. When I changed it out the ran unit ran as it should

Toilet fills slowly. Customer plans on remodeling the bathroom and would like to wait to decide is she wants a new toilet or to rebuild tank of current one. There was lots of hair in the shower drain causing it to drain slow, once I cleared it the drain worked as it should

When I got here the compressor wasn’t running. After checking the capacitor I found it was bad. I changed it out with a new one and the unit started operating properly

Identified a weak capacitor during AC inspection. Replaced it with a new 45+5 MFD dual run capacitor. Tested the system to ensure proper operation, verifying correct startup and cooling efficiency. This replacement restores optimal AC performance and prevents future malfunctions. Regular inspections are recommended to maintain system reliability.

Completed the installation of a whole-home air purification system to enhance indoor air quality. Installed a Honeywell F300 electronic air cleaner, which uses high-efficiency filters to capture airborne particles and allergens. Integrated the system with the existing HVAC unit for seamless operation. Tested the system to ensure it was functioning correctly and explained the maintenance procedures to the homeowner. Also addressed a leaking kitchen faucet, temporarily stopping the leak. Provided an estimate for replacing both the kitchen faucet and the basin faucet to ensure long-term functionality and efficiency.

Found unit is low on R22. Also found blower capacitor is out of spec. Rating is 10 I was reading 3.8. Also recommend replacing blower due to damaged windings. New system quoted for customer reference. Office to finalize quotes and provide to customer.

I cleared main drain plug with medium auger and verified proper operation. Inspected with camera.

Augered drain, did not open. Needs quoted to replace and dig new main drain.

I found backed up drains in country not town, suspect septic tank may be full. Pulled toilet and waiting on layman septic to come pump it out. May auger, depends on tank pumping, but need to reset toilet.

Replaced existing capacitor with heavy duty turbo capacitor.

This morning, I completed HVAC maintenance on a Trane XR16 system. I replaced the capacitor and cleaned the condenser coils using a non-acidic foaming cleaner to ensure efficient operation and prolong equipment lifespan.

Customer is having a hard time getting hot water to the upstairs radiator. I recommended that he should get a circulation pump for the upstairs. Customer says he will do it on his own.

The customer reported their heating system was not emitting warm air and was making unusual sounds. Upon inspection, I identified a faulty ignitor (model IG1121) and a worn blower motor (model BM2123) as the culprits. I replaced the ignitor and blower motor, then recalibrated the system for optimal performance. Post-repair, the heater resumed producing warm air quietly and efficiently.

For this job, the customer was having problems with no hot water. So I diagnosed the electric water heater to find, the heating element was bad. So I talked to the customer what I found, and I recommend replacing the heating element and the thermostat. With the customer’s permission, I created an estimate for both parts, and she gave the OK to have them replace After removing the bad parts, and installing the new ones, I checked the operation of the water heater and found it Working properly. I did not find any other issues with this system The water heater is working in normal operation