Plumbing & HVAC Services Wauseon OH

Performed precision tuneup on boiler. Unit wasn’t staying lit after the burners came on, after cleaning the flame sensor the unit is working as it should

Checked furnace and it had no codes. check flame sensor and It was reading properly was not able to check combustion due to not having the tool on my truck but customer would like us to come out and do a maintenance ASAP on the system.

Found flame sensor to be dirty and reading low. Cleaned flame sensor and verified reading of 3.2. Furnace is operating properly.

1. Running power out to outside light pole and installing a day/night sensor.(currently no power) 2. Installing two customer supplied garage lights on both sides of the garage door.(currently no power there) 3. Installing two light/fans in upstairs porch. 4. Replacing the kitchen light. We will have to run wire from panel to light post, pull wire down wall and install a switch in the garage, pull wire from existing light to second new light. We were not able to get a wire run across the ceiling for the upstairs. So we will have to return with some low profile, wire, hide and run it externally on the ceiling to the second fan. Everything else is complete

When arriving at the customers house thermostat on to AC, then I proceeded to put my gauges on the AC unit, and I found a pressure are low. The system is about 4 pounds of R22. And customer had asked if I could get the water out of the drain pan because water was leaking on the floor. I went to get water out of the call pan to find its draining good. But I did see rust and corrosion all over the coil fittings.

Customer said he will give us a call when he needs to get it inspected and cleaned

Found no evidence of the smell. Verified everything was venting properly and verified that the furnace had nothing stuck in it. Could not find source to problem.

Performed the heating tuneup on the 90% boiler System did not want to stay lit right away Found the flame sensor dirty Pulled and cleaned the flame sensor Cleaned the trap Insured the boiler is working properly before leaving

Customer reported their water heater no longer capable of keeping up with demand. Determined the interior heating element was going bad and replaced it with a new element. Informed customer we would follow up to make sure water heater was working as needed.

Customer reported that their bathtub was slow to drain. Investigated and found out that there was not only a clog but the drain itself had rusted out/damaged to the point it was adding to the clog. Installed new tub drain and verified tub was draining

Furnace not working, no heat, furnace repair.